Question : I have bobcat modell #763 Year 2002 ACS light is on and paket not working wat is rong??? Answer : HI The acs light is (Advanced control system) What you wan to do is first disconnect the battery then re connect it see if every thing is working If the ACS light comes back on chances are the actuators are out of calibration or there is a bad actuator, calibration goes like this, with your elbow on the left handle push it down toward your thigh all the way till it stops, then while you hold it there reach across with your hand to the right handle and pull it down in the same fashion, then with your free hand turn the key on (don’t start it, just to the on position) and hold the handles in position for 5 seconds before releasing, then start and check operation, it’s very possible that this will not fix it most likely you have a bad actuator this is the calibration procedure we used when we replaced actuators, lean on the service manager at the dealership for some warranty help even tho yours is out of warranty, I don’t remember a price on the actuator
Question : is it possible to trace a used tractor Answer : Yes the dealership can trace the tractor past ownership and give you the info on it. You will need the S/N to get the info
Question : I emailed about a STOP Engine sensore that is on – I have the truck at the dealership but they cant run codes – the unit is a F650 Rollback – we are afraid to drive it they cant check the codes saying it is above them please call me or zip me back phone is XXX-XXX-XXXX thank you Answer : Hi, The only faults that will cause the engine protection system to shut down the engine are Low Oil Pressure High Coolant Temperature Low Coolant Level, (if fitted) There are other faults that will cause the engine to not run, usually related to common rail fuel pressure, either too high or too low, with most of the other faults the engine will still run. You cannot check the common rail fuel pressure with a gauge, it can be up to 1800 bar pressure. Check the fuel supply at the filter by turning the keyswitch to the run position and let the lift pump run for its 45 second cycle, this will establish low pressure fuel delivery
Question : I have a 2002 John Deere self propelled mower with the Intek series 121602 engine. I cannot remove the oil dipstick.
Question : please help. my 70 year old father inlaw has had nothing but trouble since he purchased a new lt155 john deere ride on lawn mower. is this common for this supposedly top brand mower?
Question : john deere 316 won’t start. cranks but no spark. replaced ignition switch Answer : With the key in the on position you should have 12 volts on the positive side of the coil.