I have a 2007 kenworth t800 with a isx cummins how do i get

Sep4
 

Question : I have a 2007 kenworth t800 with a isx cummins how do i get the fault codes to come up on my dash Answer : hello there are several ways now a days if you have an info center on the cluster there a control on right side of sterring wheel on the column. if not look for a switch labeled DIAG this will flash out codes via check engine light

Continue Reading »

 

I hooked up my scanner and got a code 128 254 8 It is an ISB

Sep3
 

Question : I hooked up my scanner and got a code 128 254 8 SID It is an ISB 230 engine can you tell me what is the problem Answer : Thanks XXXXX XXXX code is for the vp44 pump, my suggestion is to ensure you have a new filter on the engine, and verify the lift pump is working( you should be able to hear it at key on) if not that will need to be replaced first. if you replace it it could of been too late and you will need a new vp44 pump because if the vp44 pump struggles to pull fuel from the tank with out the aid of the lift pump it prematurely makes the pump fail. CODE REASON Fault Code: 368 PID: P0216, S254 SPN: 1078 FMI: 8 The VP44 fuel pump can not achieve the timing value being commanded by the engine electronic control module (ECM) due to an internal pump problem.

Continue Reading »

 

bobcat 320 new 100 hours, forest cutter 60′ new, after oil

Sep1
 

Question : bobcat 320 new 100 hours, forest cutter 60′ new, after oil heats up, can’t control the tilt on the cutter head, wants to go down at any pressure change on the head. Any suggestion? Answer : Will it hold its position with control valve in neutral

Continue Reading »

 

I have Fasco ceiling fan model RM452WBR and the fan speed controller

Aug31
 

Question : I have Fasco ceiling fan model RM452WBR and the fan speed controller 6400-8020 on the wall remote control has stopped working even though I replaced with a new battery. The chain on/off on the fan makes a strange noise which lasts only a couple of seconds when I turn it on and the fan does nothing with no movement as when I turn it off

Continue Reading »

 

JD2020 Hydraulic Issue. Please note: This tractor is a diesel

Aug28
 

Question : JD2020 Hydraulic Issue. Please note: This tractor is a diesel with Hi-Lo Shift and dual clutch

Continue Reading »

 

Sirs, I have a DW 5110 trencher. The front blade operates

Aug25
 

Question : Sirs, I have a DW 5110 trencher. The front blade operates properly, but in a short amount of time will leak down.

Continue Reading »

 

i have a marquis gold 5500 runs for 3 seconds then dies i changed

Aug23
 

Question : i have a marquis gold 5500 runs for 3 seconds then dies i changed the fuel filters . i checked the fuel pump it has a steady stream.

Continue Reading »